Getting to know the appliance
en
Display panel
In the table you can find possible settings and information in the display panel; these
differ depending on the model.
Settings for the selected programme
— - 90*
Temperature in °C
- - - -,
Spin speed in rpm
0 - 1400*
(revolutions per
minute)
1:30
Programme length
1 - 24
Finish in h (hours)
8.0 kg*
Load in kg
* Depending on the model
Status indicators for the programme progress (programme sequence)
ß, à, 0, End
Childproof lock Lights up: The childproof lock is active.
E
Door lock
è
Tap
r
Overdosage
Å
- - - - é*
* Depending on the model
10
Temperature
Maximum spin speed or - - - - (Rinse stop = without final spin,
washing remains in the water after the last rinse)
Depends on the programme selection in h:min (hours:minutes)
End of programme after ... Hours
Maximum load
Wash, rinse, spin/drain, programme end.
Flashes: The childproof lock is actived, and if the programme selector
has been adjusted or the buttons have been pressed.
Lights up: When the door can not be opened.
Lights up: Water pressure is too low. This extends the programme
duration.
Flashes: The tap has not been turned on or there is no water supply.
On if too much foam detected, one additional rinse cycle switched on.
Power consumption.