Table of Contents
Advertisement
Industrial PCs OPC5015
7.5 N
ETWORK CONNECTION
If the required drivers are installed on the device, the control system can be integrated in
an Ethernet network with 10/100 Mbit support using the Ethernet 10/100BaseT network
connector and a suitable network cable. The specifications of the underlying network
topology are to be adhered to. The drivers required to use this function can be installed
from the provided service CD if needed.
PIN NUMBER
7.6 S
COM
ERIAL
This interface should only be used for monitoring, debugging or a log printer because the
interface is not galvanically isolated.
PIN NUMBER
7.7 O
PTIONAL
A USB interface can optionally be accessible from the front. The interface is found under a
plastic cover to the right under the display. The cover has a tab on the right side, which
can be used to open it. The plastic cover is to be closed carefully after having used the
USB interface, because otherwise the protection class IP65 is not ensured on the front.
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
(RJ45)
SIGNAL NAME
1
2
3
4
5
6
7
8
(RS232)
INTERFACE
SIGNAL NAME
1
2
3
4
5
6
7
8
9
USB
CONNECTION ON THE FACEPLATE
TX +
TX -
RX +
NC
NC
RX -
NC
NC
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
1
8
19
Advertisement
Table of Contents
