Table of Contents
Advertisement
Model W1872 (For Machines Mfd. Since 06/20)
Dust.Collection
Recommended.CFM.at.Dust.Port:................. 100.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection "how-to" book.
This. machine. creates. substantial. amounts. of. dust.
during.operation..Breathing.airborne.dust.on.a.regu-
lar.basis.can.result.in.permanent.respiratory.illness..
Reduce.your.risk.by.wearing.a.respirator.and.captur-
ing.the.dust.with.a.dust.collection.system.
Item(s).Needed.
Dust Collection System ........................................1
Dust Hose 1
⁄
" ..................................................1
1
4
Hose Clamps 1
⁄
" ...............................................2
1
4
To.connect.a.dust.collection.hose,.do.these.steps:
1. Fit a 1
⁄
" dust hose over dust port, as shown in
1
4
Figure.15, and secure in place with hose clamp.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
3. If needed, use the included dust port adapter, as
shown in Figure.16. This will require (2) 1
clamps.
Dust Port
Qty
Figure.15. Dust port connected to dust
⁄
" hose
1
2
Figure.16. Dust port adapter.
-17-
collection system.
Advertisement
Table of Contents
