Table of Contents
Advertisement
P6500 array, the iSCSI or iSCSI/FCoE modules are issued reset mappings and are rebooted, to
avoid stale persistent data, without clearing configured IP addresses.
NOTE:
A Restore action will reboot the iSCSI or iSCSI/FCoE modules.
Figure 40 iSCSI controller configuration selection
To save or restore the configuration:
1.
Select the iSCSI controller in the Navigation pane.
2.
Select Set Options.
3.
Select Save/Restore configuration.
4. Select the configuration method.
Locating the iSCSI or iSCSI/FCoE modules
A blue UID LED (1,
iSCSI and iSCSI/FCoE modules to indicate its location when the LED is flashing. The amber MEZZ
LED (2,
Figure 41 (page
Figure 41 Controller UID LED and iSCSI module status LED
1. UID LED
To locate the iSCSI or iSCSI/FCoE module (and make the blue UID LED flash):
1.
Select the iSCSI Controller in the Navigation pane.
2.
Select Locate on the iSCSI Controller Properties window
46
Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View
All manuals and user guides at all-guides.com
Figure 41 (page
46)) on each P6000 controller is shared by the array and the
46)) indicates the status of the iSCSI or iSCSI/FCoE module.
2. MEZZ LED
(Figure 42 (page
47)).
Advertisement
Table of Contents
