Installation instructions
4.6. Assembling the pent roof
Note the position of the block planks with the sections for roof ventilation.
Attach the right-hand and left-hand pent roof elements and assemble the remaining
block planks.
4.7. Assembling the inner roof
Assemble the roof support strips. Distance to the top edge: 210 mm.
Put the roof elements in place. Please note: If the roof elements are screwed
together from above, it will not be possible to access the roof space later.
For wood-fuelled sauna heaters, now cut out the fireplace section.
For electric sauna heaters, now lay the cables.
4.8. Assembling the floor
Assembling the floorboards on the base frame
Attach the floor cover strips to the block planks — do not attach the strips to the
Make sure that the walls are at a distance of 5 mm to allow the wood to
expand and contract as the temperature changes.
floorboards!
4.9. Assembling the interior fittings
Assemble the bench support strips, benches and backrest
Assemble the heater protection grille, foot step and ventilation slide
4.10. Assembling the outer roof
Place the roof rafters in the recesses as shown and screw them to the block planks.
Attach the tongue and groove boards to the rafters — start from the back. Make
sure that the boards are consistently parallel!
Attach the support strips and finally the wind battens to the front and back.
4.11. Assembling the accessories
Assemble the corner covers
Assemble the outer ventilation grille
p. 14/14