Pnp/Pci Configuration - Lanner electronics EM-568 Series User Manual

Chapter 3 BIOS Setup

3.8 PnP/PCI Configuration

Both the ISA and PCI buses on the CPU card use system IRQs & DMAs. You must set up the IRQ and DMA
assignments correctly through the PnP/PCI Configuration Setup utility; otherwise the motherboard will not work
properly.
PnP/PCI Configuration Setup Screen
PNP OS Installed
Reset Configuration Data
Resources Controlled By
IRQ Resources
DMA Resources
Memory Resources
PCI/VGA Palette Snoop
PCI Latency Timer (CLK)
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
Move Enter: Select +/-/PU/PD: Value F10: Save Esc: Exit F1: General Help
PNP OS Installed: When set to Yes , BIOS will only initialize the PnP cards used for booting (VGA, IDE, SCSI).
The rest of the cards will be initialized by the PnP operating system like Windows 95 or 98. When set to No ,
BIOS will initialize all the PnP cards. So, for non-PnP operating system (DOS, Netware), this option must set to
Yes .
Reset Configuration Data: Normally, you leave this field Disabled , Select Enabled to reset Extended System
Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system cannot boot.
The settings are: Enabled and Disabled .
42
Phoenix – Award BIOS CMOS Setup Utility
PnP/PCI Configurations
[No]
[Disabled]
[Manual]
[Press Enter]
[Press Enter]
[Press Enter]
[Disabled]
[32]
[Auto]
[Auto]
[Auto]
[Auto]
F5: Previous Values
Menu Level
Select Yes if you are
using a Plug and Play
capable operating
system. Select No if
you need the BIOS to
configure non-boot
devices.
F7: Optimized Defaults
Item Help
User's Manual