Pnp/Pci Configuration - Lanner electronics EM-660 Series User Manual

3.8 PnP/PCI Configuration

Both the ISA and PCI buses on the CPU card use system IRQs & DMAs. You must set up the IRQ and
DMA assignments correctly through the PnP/PCI Configuration Setup utility; otherwise the motherboard
will not work properly.
PnP/PCI Configuration Setup Screen
PNP OS Installed
Reset Configuration Data
Resources Controlled By
IRQ Resources
!
DMA Resources
!
Memory Resources
!
PCI/VGA Palette Snoop
PCI Latency Timer (CLK)
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
# $ % Move Enter: Select +/-/PU/PD: Value F10: Save Esc: Exit F1: General Help
PNP OS Installed: When set to "Yes", BIOS will only initialize the PnP cards used for booting (VGA, IDE,
SCSI). The rest of the cards will be initialized by the PnP operating system like Windows® 95 or 98.
When set to "No", BIOS will initialize all the PnP cards.
Netware®), this option must set to "Yes".
Reset Configuration Data: Normally, you leave this field "Disabled", Select "Enabled" to reset Extended
System Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system cannot boot.
The settings are: "Enabled and Disabled".
User's Manual
Phoenix – Award BIOS CMOS Setup Utility
PnP/PCI Configurations
[No]
[Disabled]
[Manual]
[Press Enter]
[Press Enter]
[Press Enter]
[Disabled]
[32]
[Auto]
[Auto]
[Auto]
[Auto]
F5: Previous Values
Menu Level !
Select Yes if you are
using a Plug and Play
capable operating
system. Select No if
you need the BIOS to
configure non-boot
devices.
F7: Optimized Defaults
So, for non-PnP operating system (DOS,
Chapter 3 BIOS Setup
Item Help
47