Lanner electronics EM-568 Series User Manual page 45

Video Off In Suspend: This option is for choosing the setting in which the monitor will turn off. The default
setting is Suspend .
Always On
Suspend
All Modes
Video Off Method: This determines the manner in which the monitor is blanked. The default setting is V/H
SYNC+Blank .
V/H SYNC+Blank
Blank Screen
DPMS
Suspend Mode: Power saving by suspends mode setting.
HDD Power Down: Options are from 1 Min to 15 Min and Disable . The IDE hard drive will spin down if it is
not accessed within a specified length of time.
LPT & COM: Print Port and COM Port turn on/off.
Power On by LAN/Ring: When Enabled, an input signal on the serial LAN/Ring Indicator (RI) line (in other
words, an incoming call on the modem) awakens the system from a soft off state.
Power On by RTC Alarm: Power-on interval by RTC setting.
PwrOn After AC Power Loss: This option specifies the Power ON/OFF Status after AC power loss.
User's Manual
Always turn on.
During Suspend mode, the monitor will be turned off.
During All Modes mode, the monitor will be turned off.
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blank to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
Chapter 3 BIOS Setup
41