Lanner electronics EM-568 Series User Manual page 41

Chapter 3 BIOS Setup
PCI#2 Access #1 Retry: When disabled, PCI#2 will not be disconnected until access finishes. When
enabled, PCI#2 will be disconnected if max retries are attempted without success. The default setting is
Enabled .
AGP Master 1 WS Write: Implements a single delay when writing from the AGP Bus. Normally, two wait
states are used, allowing for greater stability, but check with your motherboard manufacturer to see if they
have already implemented a Master latency of zero, in which case the lowest writing here of 1 will reduce
performance.
AGP Master 1 WS Read: Implements a single delay when reading from the AGP Bus. Normally, two wait
states are used, allowing for greater stability, but check with your motherboard manufacturer to see if they
have already implemented a Master latency of zero, in which case the lowest reading here of 1 will reduce
performance.
User's Manual
37