Set Supervisor / User Password - Lanner electronics EM-568 Series User Manual

Chapter 3 BIOS Setup

3.11 Set Supervisor / User Password

The SUPERVISOR/USER PASSWORD utility sets the password. The SBC is shipped with the password disabled.
If you want to change the password, you must first enter the current password, and then at the prompt -- enter
your new password. The password is case sensitive, and can be up to 8 alphanumeric characters. Press
<Enter> after you have finished typing in the password. At the next prompt, confirm the new password by
re-typing it and pressing <Enter> again. When you are done, the screen automatically reverts to the main
screen. Remember that when you use this feature, the Security Option line in BIOS FEATURES SETUP will
determine when entering the password will be required.
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management
PnP / PCI Configure
ESC: Quit
F10: Save & Exit Setup
To disable the password, press the <Enter> key instead of entering a new password when the Enter
Password in the dialog box appears. A message will appear confirming that the password is disabled.
If you have set both supervisor and user password, only the supervisor password allows you to enter the BIOS
SETUP PROGRAM.
Note: If you forget your password, the only way to solve this problem is to discharge the CMOS memory.
46
Phoenix - Award BIOS CMOS Setup Utility
Enter Password:
Change/Set/Disable Password
PC Health Status
Load Optimized Defaults
Set Supervisor Password
Set User Password
setup
Saving
: Select Item
User's Manual