NPort's Pair Connection Mode Moxa Technical Support Team support@moxa.com Contents What is Pair Connection Mode? ................. 2 How to Configure Pair Connection Mode ..............3 DE-211/DE-311/DE-311M ................3 NPort 5000 Series ................... 3 NPort Wireless Series and NPort 6000 Series ..........4 How to Test Pair Connection Mode ................
NPort's Pair Connection Mode This Tech Note applies to the following NPort device server models: • NPort DE-211 NPort DE-311 • • NPort DE-311M NPort 5100 Series • NPort 5200 Series • NPort 5400 Series • NPort 5600 Series •...
Moxa Tech Note NPort's Pair Connection Mode How to Configure Pair Connection Mode Before continuing, push the “RESET” button for 10 seconds to reset your NPort to its default settings. DE-211/DE-311/DE-311M 1. Power ON the NPort; the Ready LED indicator will light up in green. 2.
Moxa Tech Note NPort's Pair Connection Mode NPort Wireless Series and NPort 6000 Series 1. Power ON the NPort; the Ready LED will light up in green. 2. Connect the host PC and NPort to the network. 3. If necessary, reconfigure the IP address and netmask of your PC and the NPort so that they are on the same subnet.
Moxa Tech Note NPort's Pair Connection Mode How to Test Pair Connection Mode 1. Configure NPort#1 for Pair Connection Master and NPort#2 for Pair Connection Slave, and then assign proper IP addresses to both NPorts. 2. Connect a different PC to each of the two NPorts’ serial ports, and then use terminal software (e.g., HyperTerminal or Moxa’s PComm Terminal Emulator) to test communication.