Table of Contents
Advertisement
Labels on tool
Some or all of the following pictograms along with the date
code are shown on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear safety glasses or goggles
Wear ear protection
Wear a dust mask
Keep hands away from blade
No Hands Zone - Keep fingers and arms away
from rotational saw blades
Wear gloves when handling saw blades
Do not stare at operating lamp
Do not expose to rain.
Disconnect the mains plug if the cord
becomes damamged or entangled.
#
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Voltage drops
Inrush currents cause short-time voltage drops. Under unfa-
vourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower
than 0.214 Ω, disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Use of an extension cable not suitable for the power input of
the tool or which is damaged or defective may result in a risk
of fire and electric shock.
(Original instructions)
Features
This tool includes some or all of the following features.
1. Bevel lock knob
2. Clamp lock screw
3. Work piece clamp
4. Table extension rail
5. Bolt holes
6. Mitre angle indicator
7. Kerf plate
8. Mitre lock knob
9. Base plate
10. Rotary table
11. Rear fence
12. Saw blade
13. Blade guard
14. Safety guard mounting plate
15. Motor housing
16. Saw head locking pin
17. Main handle
18. Trigger switch
19. Safety release lever
20. Cut line light on/off button
21. Extension rail locking screw
22. Dust bag
23. Bevel angle indicator
23a.Bevel angle scale
24. Spindle lock
25. Blade change tool
Assembly
Your mitre saw is part assembled in the carton.
Open the box and lift the saw out.
u
Place the saw on a smooth, flat surface such as a work-
u
bench or strong table.
Examine Assembly diagram on page 3 of this manual to
u
become familiar with the saw and its various parts. The
section on adjustments will refer to these terms and you
must know what and where the parts are.
When the tool is shipped, the head is locked in the
u
lowered position by the saw head locking pin (16). Lightly
push down on operating handle (17), pull locking pin (16)
outwards and rotate 90° to hold in open position.
Slowly release downward pressure on handle and allow
head to move upwards into operating position.
Table extension rail (Fig. B)
Your mitre saw is supplied with 2 table extension rails (4)
to support long overhanging workpieces. Rails are supplied
loose in the carton and have to be fitted.
Once fitted:
Pull the table extension rail (4) to the required length for
u
the workpiece as shown in figure B.
Secure in position by tightening the extension rail locking
u
ENGLISH
.
11
Advertisement
Table of Contents
