Declaration Of Performance - Grundfos UNILIFT APG Safety Instructions And Other Important Information

UK declaration of performance
GB: Declaration of performance
UK declaration of performance in accordance
with The Construction Products Regulation 2019
1. Unique identification code of the product type:
• EN 12050-1
2. Type, batch or serial number or any other element
allowing identification of the construction product as
required pursuant to Article 11(4):
• UNILIFT APG pumps marked with EN 12050-1 on the
nameplate.
3. Intended use or uses of the construction product, in
accordance with the applicable harmonised technical
specification, as foreseen by the manufacturer:
• Pumps for pumping of wastewater containing faecal
matter marked with EN 12050-1 on the nameplate.
4. Name, registered trade name or registered trade mark
and contact address of the manufacturer as required
pursuant to Article 11(5):
• Grundfos Holding A/S
Poul Due Jensens Vej 7
8850 Bjerringbro
Denmark.
5. NOT RELEVANT.
6. System or systems of assessment and verification of
constancy of performance of the construction product as
set out in Annex V:
• System 3.
7. In case of the declaration of performance concerning a
construction product covered by a harmonised standard:
• TÜV Rheinland LGA Products GmbH, identification
number: 0197.
Performed test according to EN 12050-1 under
system 3.
(description of the third-party tasks as set out in
Annex V)
• Certificate number: TÜV-Certificate No R 60162792.
Type-tested and monitored.
8. NOT RELEVANT.
9. Declared performance:
The products covered by this declaration of performance
are in compliance with the essential characteristics and
the performance requirements as described in the
following:
• Standard used: EN 12050-1:2001
10 The performance of the product identified in points 1 and
. 2 is in conformity with the declared performance in point
9.
112