Table of Contents
Advertisement
Weekly Timer
The power supply has a timer control that allows you to set an automatic cleaning schedule each week. Be sure the cleaner
is fully immersed in water before turning on the power.
Setting the Weekly Timer
When the power supply is switched on, you may choose a pool cleaning
schedule for the coming week by pressing the Weekly Timer button.
Note: The cleaner will always begin to work upon set-up.
Schedule LEDS:
LED 1 - The cleaner will automatically work every day for a full cycle
= 7 times per week. Press the Weekly Timer button once to
select this interval.
LED 2 - The cleaner will automatically work every other day for a full
cycle = 3 times per week. Press the Weekly Timer button
twice to select this interval.
LED 3 - The cleaner will automatically work every 3 days = 2 times
a week. Press the Weekly Timer button three times to select
this interval.
Pressing the Weekly Timer button four consecutive times will reset the cleaner's schedule. If you do not press any of the
buttons within the first 5 seconds after the power has been switched on, the cleaner will default to running one cycle only.
While the cleaner is working in weekly timer mode, the appropriate Weekly Timer LED will blink constantly between cycles.
At the end of the week the power supply automatically shuts off.
KREEPY KRAULY
PROWLER
®
920 Robotic Inground Pool Cleaner Installation and User's Guide
®
OPERATION
3 Schedule
LEDs
1
Weekly Timer
On/Off
Button
Button
3
2
3
Advertisement
Table of Contents
