Table of Contents
Advertisement
Control Panel Overview
Weekly Timer Feature
The power supply has a timer control that allows you to set an automatic cleaning schedule each week. Be sure the cleaner
is fully immersed in water before turning on the power.
Setting the Weekly Timer
When the power supply is activated, you may choose a pool cleaning schedule for the coming week by pressing the Weekly
Timer button.
Note: The cleaner will always begin to work upon set-up.
Schedule LEDS:
LED 1 - The cleaner will automatically work every day for a full cycle = 7 times per week. Press the Weekly Timer
button once to select this interval.
LED 2 - The cleaner will automatically work every other day for a full cycle = 3 times per week. Press the Weekly Timer
button twice to select this interval.
LED 3 - The cleaner will automatically work every 3 days = 2 times a week. Press the Weekly Timer button three times
to select this interval.
Pressing the Weekly Timer button four consecutive times will reset the cleaner's schedule. If you do not press any of the
buttons within the first 5 seconds after the power has been switched on, the cleaner will default to running one cycle only.
While the cleaner is working in weekly timer mode, the appropriate Weekly Timer LED will blink constantly between cycles.
At the end of the week the power supply automatically shuts off.
Cleaning Speed (Quick Clean Feature)
The Prowler
930 or Warrior
®
or at a higher cleaning speed referred to as Quick Clean.
1. The cleaner's default speed is symbolized by the
default cleaning cycle the LED under this icon will illuminate.
2. Quick Clean is symbolized by the
cycle the LED under this icon will illuminate.
To begin a Quick Clean cycle, press the Cleaning Speed button once. The cleaner will immediately enter Quick Clean
mode and will clean the pool for one hour.
Note: While in Quick Clean mode the cleaner will only clean the pool floor. The cleaner will NOT climb and clean pool
walls.
Note: Once Quick Clean is selected, the cleaner will continue to clean in Quick Clean mode each time the cleaner is
activated. To return to the default cleaning cycle the Cleaning Speed button must be pressed while the cleaner is active.
Bluetooth
Wireless Technology
®
Connection Indicator
On/Off
Button
SI Robotic Pool Cleaner can be set to clean your pool at either its standard cleaning speed
®
icon on the power supply. When the cleaner is performing a Quick Clean cleaning
PROWLER® 930 and WARRIOR® SI Robotic Inground Pool Cleaner Installation and User' s Guide
3 Schedule
2 Cleaning
LEDs
Speed LEDs
1
2
3
Weekly Timer
Cleaning
Button
Speed Button
icon on the power supply. When the cleaner is performing a
5
OPERATION
Advertisement
Table of Contents
