Pentair KREEPY KRAULY PROWLER 920 Installation And User Manual page 6

2
STEP 4:
Connect Power Supply to Power Source
Connect the power supply to the electrical source/outlet.
See Figure 4.
R I S K O F E L E C T R I C A L S H O C K O R
ELECTROCUTION: Connect only to a grounding
type receptacle protected by a ground-fault circuit-interrupter
(GFCI). Contact a qualified electrician if you cannot verify that the
receptacle is protected by a GFCI.
To reduce the risk of electrical shock, do not use
extension cord to connect unit to electrical supply;
provide a properly located outlet.
Figure 4
KREEPY KRAULY
PROWLER
®
920 Robotic Inground Pool Cleaner Installation and User's Guide
®
STEP 5:
Placing the Cleaner in the Pool
Do not switch the pool cleaner to "ON" if it is not
fully immersed in water. Operating the cleaner out
of water will immediately cause severe damage and will result in loss
of warranty. Do not leave the cleaner in the pool all the time. Always
remember to turn the power supply "OFF" and unplug it from the power
outlet before removing the cleaner from the pool.
1. Be sure the power supply is positioned at least 10 feet
(3 m) from the pool.
2. Lower the cleaner into the pool by the handle (see
Figure 5).
Note: Never lower the cleaner into the pool by the
floating cable. This puts an unnecessary strain on the
cable and could result in damage to the cleaner.
3. Gently tilt the cleaner from side to side or turn upside
down to release trapped air. See Figure 6.
Figure 5 Figure 6