Supero 2122TG-HIBQRF User Manual page 66

A+ SERVER 2122TG-HIBQRF/HTRF USER'S MANUAL
Chassis Intrusion
A Chassis Intrusion header is located at JL1.
Attach the appropriate cable to inform you of
a chassis intrusion.
Overheat LED
Connect an LED to the JOH1 header to
provide warning of chassis overheating. See
the table on the right for pin definitions.
IPMB
A System Management Bus header for the
IPMI slot is located at IPMB. Connect the
appropriate cable here to use the IPMB I2C
connection on your system.
Unit Identifier Button
A Unit Identifier (UID) button is located on
the rear of the board. There is another UID
button located on the control panel. When
you push either UID button, both Rear
UID and Front Panel UID Indicators will
illuminate. Push either button again to turn off
both indicators. These UID indicators provide
easy identification of a system unit that may
be in need of service.
Video Connector
A Video (VGA) connector is located below
the COM Port on the IO backplane. This
connector is used to provide video and CRT
display.
Chassis Intrusion
Pin# Definition
1
2
Pin# Definition
1
2
Pin# Definition
1
2
3
4
Pin#
1
2
3
4
5-14
Pin Definitions
(JL1)
Battery voltage
Intrusion signal
Overheat LED
Pin Definitions
(JOH1)
3.3V
OH Active
IPMB
Pin Definitions
Data
Ground
Clock
No Connection
UID Button
Pin Definitions
Definition
Ground
Ground
Button In
Ground