Section 6 - Replacing Lens Covers; Replacing The Lens Covers - Miller Ultra HDV Owner's Manual

SECTION 6 – REPLACING LENS COVERS
6-1.

Replacing The Lens Covers

2
Never use the auto-darkening lens
without the inside and outside lens
covers properly installed. Welding
spatter will damage the auto-darken-
ing lens and void the warranty.
Outside Lens Cover
1 Outside Lens Cover
2 Outside Lens Cover Release Points
Remove outside lens cover by pulling the
cover away from the helmet on either side of
the lens cover.
Inside Lens Cover
3 Auto-Darkening Lens
4 Inside Lens Cover
2
4
3
1
5
Remove the inside lens cover by pulling top
center of lens cover from lens holding chan-
nels. Replace the lens cover by gently bow-
ing it in the center and inserting it, one end
at a time, into the lens holding channels.
�
Be sure the cover lens is seated prop-
erly to prevent fogging.
Auto-Darkening Lens
5 Lens Release Tab
Remove outside lens cover as instructed
previously. Press up on lens release tab
while pushing auto-darkening lens assembly
out of shell from the inside.
Reinstall lens by aligning lens on release
tabs. Press on lens until it snaps into place.
OM-288717 Page 17