Lens Delay Control - Miller Ultra HDV Owner's Manual

4-6.

Lens Delay Control

1
1 Mode (On/Off) Button
2 Lens Delay Adjustment Buttons
Use the Lens Delay Fast and Slow buttons
to adjust the time for the lens to switch to the
clear state after welding or cutting.
The delay is particularly useful in eliminating
bright after-rays present in higher amperage
applications where the molten puddle re-
mains bright momentarily after welding. Use
the Lens Delay Fast and Slow buttons to ad-
just delay from 0 to 10 (0.1 to 1.0 second).
The delay ranges for each mode are as
follows:
Weld, Cut, And X-Modes - No. 0–No. 10
OM-288717 Page 12
2
Grind Mode- No delay adjustment
�
There is no lens delay adjustment in
the Grind mode.
Lens Delay Adjustment Procedure
� Press Mode (On/Off) button to turn lens
On. Helmet control display appears.
� Press Mode button to select desired
function: Weld, Cut, or X-Mode.
� Use Lens Delay Fast and Slow buttons
to select desired delay.
� Begin welding or continue with other
lens adjustments.