Table of Contents
Advertisement
1
HEALTH & SAFETY
Note: When servicing the Induction Cooktop, health and safety issues must be
considered at all times.
appropriate icon.
1.1
Electrical Safety
1.2
Health Hazard
1.3
Electrostatic Discharge
1.4
Good Working Practices
1.5
Insulation Test
1.6
Sheet Metal Edges
WARNING! TO AVOID ELECTRIC SHOCK!
Do not attempt to service this cooktop without suitable training and
qualifications.
Ensure the mains power has been disconnected before servicing any
part of the cooktop. If the power is required to be on for electrical fault
finding, then extreme care should be taken not to make contact with
electrical components other than with testing probes.
cooktop is turned off when removing any electrical component or
connection.
This appliance complies with electromagnetic safety standards.
However, persons with cardiac pacemakers or other electrical implants
(such as insulin pumps) must consult with their doctor or implant
manufacturer before using this appliance to make sure that their implants
will not be affected by the electromagnetic field.
Failure to do follow this advice may result in the implant malfunctioning.
An anti-static strap is to be used as electrical static discharge (ESD)
protection when servicing electronic components.
Ensure the work area is kept tidy and free from hazards while servicing
the cooktop. On completion of the servicing, ensure the cooktop and
work area are left clean and tidy.
Megger test to check insulation.
Warning Short together the phase and neutral terminals to avoid
damaging any electronic circuitry.
When working around cut sheet metal edges use appropriate gloves or
protection to eliminate the chance of receiving a laceration
Specific safety issues are listed below with their
5
599653A
Ensure the
Advertisement
Table of Contents
