Table of Contents
Advertisement
599653A
While holding the keylock button – push the different keys of all existing cooking zones from
right to left.
4
2
1
5
3
Each activation of a key in combination with the pressed and held key-lock key is
confirmed with an acoustic key signal. Once all keys have been pressed, the configuration is
complete and must be stored, to do this, lift finger off the keylock button and repress, hold for
2 sec.
A double acoustic signal will advise the saved data. Then, the control starts a reset and
changes to the off mode, after configuration the cooktop is ready to use.
Note:
Each cooking zone key requires activation within 1 second from the last key press. As soon
as the sequence or the timing is not kept, there will be a short acoustic double signal – the
entry in the service menu is interrupted and the Touch Control (TC) remains in the off mode.
During entry in the service menu all possible error messages on the display will disappear.
On the front left cooking zone the current program point "0" is blinking alternating with "C".
On the back left display the current value "0" of the selected program point is shown. In
addition, the Touch Control (TC) signals the successful entry with a blinking key-lock LED.
If you want to leave the Service Menu without saving the data there are 2 possibilities:
1) Leaving the service menu by actuating the on/off key, possible changes are not saved, the
menu is closed, the control remains off.
2) The service menu is automatically closed, if there are no entries within 60s. Data is not
saved. The control unit is in off mode. This is signalized with an acoustic double signal.
31
Advertisement
Table of Contents
