DCU Tecnologic Senior User Manual page 39

ENG
Smartwatch APN Settings
The APN is what will allow the Watch to connect to your SIMs
mobile service data network. The Watch needs this data to
connect to your App. If the APN is not set, the Watch can still
call, receive calls, send and receive SMS, but the APP will show
the device's status as "Offline".
Set APN Instructions:
To set the APN on the watch, send the below SMS command to
the watch:
pw,123456,apn,(APN NAME),,,50501#
For example: For ALDI Mobile the APN name is "mdata.net.au".
Then send
"pw,123456,APN,mdata.net.au,,,50501#"
If command is successful you should have a return SMS that will
read: "Set apn,oran,,,73002 is succesful"
Common Australian APN based on network providers:
Watch Positioning Methods
The device supports GPS tracking (Outdoor), Wi-Fi tracking
(Outdoor and Indoor), LBS tracking (Outdoor and Indoor). GPS
uses satellites that orbit around the Earth to triangulate the
user's location, whereas Wi-Fi locating technology uses relative
network signal strength gathered at network access points. GPS
tracking is available indoors but not recommended, as the
location is prone to bouncing. When the Smartwatch doesn't
find a GPS signal, it will use Wi-Fi or LBS tracking.
Wi-Fi tracking is better for indoor comparing with LBS tracking.
Positioning accuracy
GPS/AGPS: 5-15m WIFI:15-100mLBS:100-1000m
Reasons for inaccuracy:
1. If the Smartwatch is indoors, it will now have a clear line of
sight with at least three GPS satellites.
2. The environment around the Smartwatch plays a big part in its
accuracy. Any environmental obstructions such as mountains,
tin roofs, buildings, or even heavy
tree cover can skew the satellite's connection.
3. Ensure you have set your GPS positioning interval to 1 minute,
10 minutes OR 1 hour.
NOTE: In order to save battery power, if the tracker is not
moving, it will not upload data positioning to the APP. You can
39