Setting The Output Mode - Boss Giga Delay DD-20 Owner's Manual

Settings Made When the Power is Switched ON

Setting the Output Mode

When using the DD-20 while connected to a guitar or bass amp, mixer, or
multitrack recorder SEND/RETURN, you can set the output level (+4 dB) and
method of output from the OUTPUT jacks (A: Direct Sound/B: Effect Sound) to
match the device connected to the DD-20.
1. Switch off the power.
2. While holding down the ON/OFF pedal, switch on the power.
The output mode setting is indicated in the display, and the MEMORY 1–4
indicator corresponding to the current setting flashes.
3. Set the output mode pressing the SELECT button.
fig.44
Output Mode 1
4. Press the WRITE button.
After the MEMORY Number indicator begins flashing rapidly, the setting is stored
in memory and the unit returns to its ordinary state.
* To cancel the setting change and return the unit to its ordinary state, then before you press
the WRITE button, operate the MEMORY/TAP or ON/OFF pedal.
Display
out1
out2,
A:DIR / B:EFX
out3, +4dB
out4,
A:DIR / B:EFX, +4dB
* Even when this is set to "A: Direct Sound/B: Effect Sound," if the input is in stereo, then
the output will also be in stereo. Additionally, if the input is mono while nothing is
connected to the OUTPUT B jack (effect sound), then the sounds are not output as "A:
Direct Sound/B: Effect Sound." If you want to have the output be "A: Direct Sound/B:
Effect Sound," then set the DD-20 so that "A:DIR, B:EFX" appears in the display.
* This is set at the factory to "Output Mode 1."
30
Output Mode 2
Mode
1 Stereo output
A: Direct Sound/B: Effect
2
Sound
3 Stereo output
A: Direct Sound/B: Effect
4
Sound
Output Mode 3
Output
Output Mode 4
Level
-20 dB
-20 dB
+4 dB
+4 dB