Advertisement
OPERATION
ELECTRIC FIREPLACE MANUAL CONTROL
The manual controls for the fi replace are located in the upper right hand corner. (FIGURE 4)
A. Main On/Off Switch
Supplies power to the 3 position manual control switch.
B. 3 Position Manual Control Switch
Remote (left position): The unit is operated with the remote control.
Flame (center position): The fl ame effect is turned ON.
Flame & Heat (right position): The fl ame effect and heater are turned ON simultaneously.
When the manual control is in the Flame & Heat position the heater does not run on the
remote operated thermostat. When the heater is ON the red indicator light is activated on the
fi rebox and the fan and heater are running on low.
NOTE
When the manual control switch is in the Flame and Flame & Heat positions, the fi replace unit will
not operate with the remote control.
FIGURE 4
C. Initialization Button
Used to synchronize the remote control to the fi replace.
RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic switch will turn the heater off and it will not come back on
without being reset. The temperature cutoff switch can be reset by unplugging the unit, waiting 5 minutes
and plugging the unit back in.
CAUTION
If you need to continuously reset the heater, unplug the unit and call your local dealer.
REMOTE CONTROL
The remote control has a range of approximately 15.25m, it does not have to be pointed at the fi replace
and can pass through most obstacles (including walls). It is supplied with 243 independent frequencies to
prevent interference with other units.
SERIAL No.
XXX
XX
A. Main
On/Off
C. Initialization
Switch
Button
Indicator
B. 3 Position
Light
Manual
Control
5
Advertisement
