Advertisement
BATTERY INSTALLATION (FIGURE 5)
1. Depress tab on the battery cover on the back of the remote
transmitter and remove battery cover.
2. Install 2 AAA batteries into the remote control (included).
3. Ensure child lock is in the "unlocked" position.
4. Replace the battery cover.
NOTE
When the "BAT" symbol is present on the remote control it is
recommended to replace the batteries promptly, to maintain full
functionality of the remote/fi replace. The remote transmitter has a
battery backup time of only several hours.
INITIALIZING THE REMOTE CONTROL
1. Plug the fi replace into a 13AMP/230Volt outlet.
2. Ensure the Main On/Off switch located in the switch box on the fi replace in the lower right hand
corner is in the
3. Set the 3 position manual control to the Remote position (left position).
4. Press and hold the initialization button on the unit.
5. While holding the initialization button, press the Flame/Heat ON/OFF
ON/OFF
button on the remote control transmitter.
6. Release the initialization button on the unit.
7. Press the Flame/Heat On/Off button
Purifi re™ On/Off button
FREQUENCY INTERFERENCE
If the fi replace does not respond properly to the remote control, the remote operating frequency may
have to be reset. The remote control can send another frequency code to the circuit board to eliminate
interference.
1. Simultaneously press the "SLEEP TIMER DOWN" button and the "PURIFIRE
button on the remote control.
2. "COD" will appear in place of the sleep timer digits.
3. Release the "SLEEP TIMER DOWN" button and the "PURIFIRE
4. Press the initialization button on the unit.
5. Press the
Your remote will now have a different frequency communicating with the fi replace.
ON position.
to turn the Purifi re™ function ON.
button on the remote.
to turn the Flame/Heat function ON or press the
FIGURE 5
button or the Purifi re™
TM
LOW SPEED"
TM
LOW SPEED" button.
Batteries
6
Advertisement
