Table of Contents
Advertisement
Section 4: Installation
August 2022
•
Figure 31
•
Figure 32
•
Figure 33
NOTE:
Please note that all the connectors provided with the base actuator and all optional cards
are different from each other (in terms of design and number of pins). In no way is it
possible to make a wrong connection.
•
•
16
Disassemble the local mechanical indicator and connect the OM9 flat cable to the
connector on the logic board, see Figure 31.
Place the OM9 card onto the spacers and tighten the 4 screws; assemble the local
mechanical indicator, see Figure 32.
Connect the 8-pin connector to connector J3 on OM9, see Figure 33.
The OM9 card is now connected.
Replace the actuator cover and fix it properly.
Installation, Operation and Maintenance Manual
screw
VCIOM-17121-EN Rev. 0
Installation
Advertisement
Table of Contents
