Quick Start - Xpd2 Wireless System - Samson Expedition Explor Owner's Manual

Quick Start - XPD2 Wireless System

1. Plug the RXD2 USB receiver into the USB
jack labeled XPD WIRELESS. There is a
USB A female to USB A male extension
cable included. This can be used to
prevent damage to RXD2 receiver, if the
Explor is knocked over or dropped.
2. On the handheld transmitter, open
the bottom section of the microphone.
Place a fresh set of AA (LR6) batteries
in the transmitter battery holder, taking
care to observe the polarity markings,
then screw the cover back on to the
lower barrel.
3. Turn the Channel 3 volume knob on
the Explor completely counterclockwise
, then turn the POWER switch on the
Explor to the ON position.
4. Turn on the power to the transmitter by
pressing and holding Power switch; the
indicator LED will light amber.
EXPLOR • Portable PA System
13