Quick Start; Making Connections - Samson Expedition Escape+ Owner's Manual

Quick Start

• Set the Escape+ power switch to the OFF position, and fully turn all of the LEVEL
controls counterclockwise to 0.
• If an outlet is available, connect the included power cord to the AC input of the
speaker, and plug it into an electrical outlet.
• Set the Escape+ power switch to the ON position.
• Connect your audio sources.
• Turn the MASTER VOL control up and set the input levels, following the steps below.

Making Connections

Microphone Input
• Connect a microphone using a 1⁄4"
instrument cable.
• Turn the MASTER VOL control about half way up.
• While speaking or singling at performance
level into the microphone slowly raise the
channel MIC VOLUME control until you have
reached the desired level.
NOTE: If not using the Mic Input, turn the MIC
VOLUME control all the way down to keep out
any unwanted noise.
Aux Input
• Connect a line level device using 1⁄8"
(3.5mm) cable.
• Set the output volume of your audio device to
it's maximum setting.
• While playing music from a line level audio
source, slowly raise the MASTER VOL control
until you have reached the desired level.
NOTE: If using the Mic Input with an Aux audio
device, use the external audio device's volume
control to balance the audio levels.
8