Troubleshooting - Alarm.Com ADC-VC847PF Installation Manual

Troubleshooting

• If you have issues connecting the camera to the account,
power cycle the camera and try again.
• If issues persist, reset the camera to factory defaults. Press
and hold the Reset button
and Red (about 15 seconds), then release the button. The
camera will reboot with factory defaults.
If the camera was previously installed to an Alarm.com
account, it will need to be deleted before it can be
installed again.
Questions?
Visit answers.alarm.com
or contact your service provider.
8 8
until the LED is flashing Green
Notices
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
9