Alarm.Com ADC-VC726 Installation Manual

Indoor/Outdoor Mini Bullet (ADC-VC726) - Installation Guide

Pre-setup checklist:

• ADC-VC726 camera (included)
• AC power adapter (required for non-PoE connections)
• Broadband (Cable, DSL or Fiber Optic) Internet connection with router
• A computer or mobile device with Internet access
• An Ethernet / Cat5 cable
• Login and Password for the Alarm.com account to which you will add the camera

Add the camera to an Alarm.com account

Complete these steps prior to installing the camera in its final location.
1. Connect the camera to the router via an Ethernet cable. For more information about connecting video devices
using PoE, see Connect a video device using Power-Over-Ethernet
2. If the Ethernet connection does not provide power, connect the camera to the optional AC power adapter (sold
separately) and plug the adapter into a non-switched outlet.
3. Wait a few minutes for the camera to connect to the Internet.
4. Add the video device to the account using either MobileTech, or entering the following web
address: www.alarm.com/addcamera
5. Follow the on-screen instructions to add and set up the video device. For more information about adding a camera
to an account, see
6. Once the camera is enrolled on the account, power down the camera and install it in its final location using the
included hardware.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Mini_Bullet_ADC-VC7
to access the Customer Website.
Enroll the video device to the customer
(PoE).
account.
Updated: Wed, 19 Jun 2019 01:30:58 GMT
1