Hypex Electronics Nilai 500 Getting Started

Getting Started with Your Hypex Nilai 500 Amplifier

Please take a moment to review the following details on your new Hypex Nilai 500 Amplifier(s), assembled by

Deer Creek Audio.

What's Included

● Assembled amplifier(s)

● Printed test results

● Power cord

Your Nilai 500 has three AC power controls

● Master on / off AC switch on the rear panel

● Standby on / off switch on the front panel

● 12 Volt trigger control input

The front switch can be used to turn on and turn off (standby) the power amplifier when the 12 Volt trigger

option is not used (when used, the 12 Volt trigger overrules the front switch).

● Balanced XLR-to-XLR or TRS-to-XLR cables are preferred

● For single-ended RCA sources, use the cable configuration in the following diagram

● Requires a minimum 13 amp, 3-prong power cord

(assembled by Deer Creek Audio)

● User Instructions

● Assembly manual

● Tool kit

Table of Contents

Do you have a question about the Nilai 500 and is the answer not in the manual?

Page 1 Getting Started with Your Hypex Nilai 500 Amplifier (assembled by Deer Creek Audio) Please take a moment to review the following details on your new Hypex Nilai 500 Amplifier(s), assembled by Deer Creek Audio. What's Included ● Assembled amplifier(s) ● User Instructions ●...
Page 2 Break-in period When you first turn on the amplifiers, allow approximately 60 minutes warm-up time before critical listening. After the amplifiers have broken in for several hours, the starting warm-up time should be approximately 10 minutes. Input Gain Jumper The Amplifier Module contains a pin header (J200) with jumper to alter the input gain setting. Voltage Gain Jumper Settings Installation Be sure to install your Hypex Class D amplifier with adequate ventilation.