Step 1; Step 2 - modway EEI-1380 Manual

EEI –1380/812

STEP 1:

Please put Chair Back (1) upside down on a carpeted or padded area.
Then open the black fabric which is attached by the Velcro from back to front on bottom of the Seat Frame (2). The inside of
the Seat Frame(2) will now be visible.
Insert 1 piece of Wooden Dowel (B) into the pre-drilled holes on Chair Back (1).
Attach Seat Frame (2) to Chair Back(1) by using 4 pieces of Bolt (A), 4 pieces of Spring Washer (C) and 4 pieces of Flat
Washer (D) as shown.
Do not fully tighten Bolts (A) at this step.
Ax4

STEP 2:

Insert 1 piece of Front Leg (3) into the upper hole on bottom of the Chair Back (1) as shown.
Attach by 2 pieces of Bolt (A), 2 pieces of Spring Washer (C) and 2 pieces of Flat Washer (D) as shown.
Repeat the same steps for the remaining Front Leg (3).
Do not fully tighten Bolts (A) for either leg.
Ax4
Customer Service 908-368-1025︱www.modwayfurniture.com
DINING CHAIR
Bx1 Cx4
3
Cx4 Dx4
2
A
C
D
B
Dx4
D
C
A
3
1
Hardware & Tool required
1
Hardware & Tool required
Page 2 of 3