Advertisement
Quick Links
EEI –1381/815
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Component:
1
Chair Back
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
CHAIR
2
3
2
Seat Frame x1
Hardware:
A
B
C
D
E
F
1
3
Bolt M8x50mm
x 1
Bolt M8x57mm
x 4
Bolt M8x90mm
x 4
Spring Washer M8
x 9
Flat Washer M8
x 9
Allen Wrench
x 1
3
Front Leg
x2
Page 1 of 3
Advertisement
Related Manuals for modway EEI-1381
Summary of Contents for modway EEI-1381
- Page 1 EEI –1381/815 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI –1381/815 CHAIR STEP 1: Please put Chair Back (1) upside down on a carpeted or padded area. Then open the black fabric which is attached by the Velcro from back to front on bottom of the Seat Frame (2). The inside of the Seat Frame(2) will now be visible.
- Page 3 EEI –1381/815 CHAIR STEP 3: Insert 1 piece of Front Leg (3) into the upper hole on bottom of the Chair Back (1) as shown. Attach by 2 pieces of Bolt (B), 2 pieces of Spring Washer (D) and 2 piece of Flat Washer (E) as shown. Repeat the same steps for the remaining Front Leg (3).
Need help?
Do you have a question about the EEI-1381 and is the answer not in the manual?
Questions and answers