Table of Contents
Advertisement
2.
Press the <FEL> button.
* Aim the subject at the center of the viewfinder and press <FEL> button.
* The camera flash will fire a preflash and the required flash output for the subject is retained
in memory.
* Each time the <FEL> button is pressed, a preflash will be fired and a new flash exposure
setting will be locked.
If the subject is too far away and underexposure, the < > icon will blink in the
viewfinder. Move closer to the subject and try the FE lock again.
If <ETTL> is not displayed on the LCD panel, FE lock cannot be set.
If the subject is too small, FE lock might not be very effective.
High-Speed Sync
High Speed Sync (FP flash) enables the flash to synchronize with all camera shutter speeds. This is
convenient when you want to use aperture priority for fill-flash portraits.
1、Press Function Button 2 <
2、Check that <
If you set a shutter speed that is the same as or slower than the camera's
maximum flash sync speed, <
With high-speed sync, the faster the shutter speed, the shorter the effective flash
range.
To return to normal flash, press <
disappear.
Multi flash mode cannot be set in high-speed sync mode.
Over-temperature protection may be activated after 15 consecutive high-speed
sync flashes.
> so that <
> is displayed in the viewfinder.
> is displayed.
> will not be displayed in the viewfinder.
> button again. Then <
> will
Advertisement
Table of Contents
