Set Priming Options - Pentair WhisperFlo VS 800 Owner's Manual

OPERATION

4. Set Priming Options

WhisperFlo VS 800 Owner' s Manual
12
, or
Press the "STOP" button for 5 seconds to
DISABLE/ENABLE prime time. (The power LED/
Green will light up and not blink when prime
time is disabled), this function will be back to
default when reset to default or press again this
button for 5 second.
Pressing any two of the speed buttons
simultaneously to finish priming time as
temporarily.
Pressing the "STOP" button for 10 seconds the
power LED/ green will blink twice in every one
second then display will show "P 2" and ready to
adjust time (Limit time to 240min maximum and
minimum for 1Min).
Pressing the button "low" will lower the time by
1 min step (Holding for 2 seconds to decrease
time continuously).
Pressing the button "high" (will rise the time by
1 min step (Holding for 2 seconds to increase
time continuously).
Pressing the button "med/set" will save the new
time then automatic go to Priming speed setup
in next step and display show "2850" and ready
to adjust speed.
Pressing the button "low" will lower the speed by
25 RPM step (Holding for 2 seconds to decrease
speed continuously).
Pressing the button "med/set" will save.