Table of Contents
Advertisement
OPERATION
4. Set Priming Options
12
800-VS Pool Pump Owner's Manual
,
or
Press the "STOP" button for 5 seconds to
DISABLE/ENABLE prime time. (The power
LED/ Green will light up and not blink when
prime time is disabled), this function will
be back to default when reset to default or
press again this button for 5 second.
Pressing any two of the speed buttons
simultaneously to finish priming time as
temporarily.
Pressing the "STOP" button for 10 seconds
the power LED/ green will blink twice in
every one second then display will show "P
2" and ready to adjust time (Limit time to
240min maximum and minimum for 1Min).
Pressing the button "low" will lower the
time by 1 min step (Holding for 2 seconds to
decrease time continuously).
Pressing the button "high" (will rise the
time by 1 min step (Holding for 2 seconds to
increase time continuously).
Pressing the button "med/set" will save
the new time then automatic go to Priming
speed setup in next step and display show
"2850" and ready to adjust speed.
Pressing the button "low" will lower the
speed by 25 RPM step (Holding for 2
seconds to decrease speed continuously).
Pressing the button "med/set" will save.
Advertisement
Table of Contents
