Table of Contents
Advertisement
Due to the PL-551 device with female socket, you should connect all additional
network devices that are connected to a multiple socket to the main power supply
via the electrical socket integrated into the PLC device with female socket. To
take full advantage of the filter function, to improve data transmission in the
network, always plug the power stripe into the female socket.
3.6 Reset Button
This section describes how to use Reset button, this button can be used to clear
ALL data and restore ALL settings to the factory default values.
The procedure is as follows:
1. Hold the reset Button down while Power On for a few seconds.
2. Release the reset button.
3. All the LEDs will off, and then start again.
4. PL-551 is now using the factory default values.
23
Advertisement
Table of Contents
