Wps Setup - Pbc (Push-Button Configuration) - Planet WNL-9501 User Manual

3-13-1 WPS Setup - PBC (Push-Button Configuration)

1.Set 'Config Mode' to 'Enrollee', and then push the 'WPS' button on your wireless access
point (the button used to activate WPS standby mode may have another name), or use other
way to start WPS standby mode as the instruction given by your wireless access point's user
manual.
2. Before you start to establish the wireless connection by using WPS, you can click 'Rescan'
button to search for WPS-enabled access points near you, to make sure the WPS function of
your access point is activated.
3.All access points found will be displayed. Please make sure the access point you wish to
connect is displayed. If not, please click 'Rescan' few more times. You can also click
'Information' button to see the detailed information about selected access point.
4.Click 'PBC' button now to start to establish wireless connection by WPS, and please be
patient (This may require several seconds to one minute to complete). When you see 'WPS
status is connected successfully' message, it means the connection between your WNL-9501
and access point is successfully connected by WPS, and the information about access point
you connected to will be displayed.