Bunn Silver JDF-4S Installation & Operating Manual page 25

TROUBLESHOOTING (cont.)
PROBLEM
Water leak filling drip tray or around
dispense deck area
Water leaking beneath machine
Erratic spray during dispense
Dispense nozzle dripping water
PROBABLE CAUSE
1. Initial fill/setup
2. Dispense deck
3. Water pressure greater than
100psi
1. Bath tank overflow.
2. Condensation from cabinet cool-
ing coil.
Dispense nozzle mixer missing or
broken
Dispense solenoid.
25
REMEDY
Some expansion normal. May fill
drip tray during initial ice block
formation
Inspect or replace fittings clamps,
o-rings, solenoids and quick discon-
nect fittings.
NOTE: Dispense deck area slopes to
drain tube that leads to the drip tray.
Install water pressure regulator and
reduce to 50 psi.
A) Check all internal water connec-
tions.
B) Check internal plumbing con-
nections.
Check for routing of condensation
tube to water bath.
Replace mixer.
Replace dispense deck solenoid.
44744.2 062912