Bunn Silver JDF-4S Installation & Operating Manual page 14

Loading Frozen Concentrates
1. Thaw the frozen concentrate in a refrigerated 35-40 degrees F (1.6-4.4 degrees C) environment for 36 to 48
hours before use.
NOTE: Loading frozen concentrate in the product cabinet may cause damage to the machine. This damage is
not covered by warranty.
2. Thoroughly mix the thawed concentrate by vigorously shaking the product container.
3. Open the dispenser door.
4. Prior to placing the product container in the dispenser, make sure that the o-ring on the container adapter is
lubricated. This will ease removal of the container when it becomes necessary.
5. Place the product container in the desired position and press it firmly into the bottle adapter opening.
6. Open the vent hole in the product container.
Note: Concentrate in the container must be completely thawed and be within the temperature range of 35-40
degrees F (1.6-4.4 degrees C.) Product outside of this temperature range, especially below, will produce an "out
of brix" drink.
Ambient Concentrates (Optional)
1. Install an Ambient Concentrate Conversion Kit (BUNN-O-MATIC part number 33699.0002) per the instruc-
tions provided in the kit.
2. Attach the concentrate product hose to the appropriate concentrate line located at the rear of the dispenser.
3. Attach the other end of the product hose to the product container through an appropriate fitting.
Priming Product
1. Open the dispenser door
2. Load concentrate per instructions in section titled Loading.
3. Close the dispenser door.
4. Place a large container under the appropriate dispense nozzle.
Press and hold the "Product Dispense Switch" until concentrate dispenses from the dispense nozzle.
Note: This may take several seconds, depending on the installation and set pump speed.
Pump Speed Adjustment (concentrate flow)
1. Disconnect the dispenser from the power source.
2. Remove the drip tray.
3. Remove the two screws securing the splash panel and remove the splash panel
4. Locate the adjustment knobs on the circuit board.Start with the adjustment dial in the nine o'clock position.
5. Turn the adjustment knobs clockwise to increase speed and counterclockwise to decrease speed.
If splashing occurs while dispensing, reduce water flow rate. Then re-adjust pump speed to achieve proper
ratio/brix target.
6. The knob positions directly correspond to dispense station locations.
Note: Some 2S models have 4 adjustment knobs on the circuit board. For these models use the two left most
knobs to make pump speed adjustments. Left most being station #1 (left side dispense) and left center being
station #2 (right side dispense).
7. Reinstall the splash panel and drip tray and reconnect the dispenser to the power source.
ADJUSTMENTS AND OPTIONAL SETTINGS
14
44744.2 110813