Recording - Nuvico HDoCS DT-P1620 Setup Manual

Setup Guide of HDoCS Digital Video Recorder
Start/Stop all live view
/
Capture pictures in the live view
mode
Start/Stop all recording
/
Enable/Disable digital zoom
/

Recording

Before you start
Make sure the device is connected with HDD or network disk, and the HDD or network disk has been initialized
for the first time to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording.
Steps:
1. Click Remote Configuration> Camera Settings> Record Schedule to enter Record Schedule settings
interface.
2. Select the camera to configure the record schedule.
3. Check the checkbox of Enable Record Schedule to enable recording schedule.
4. Click Edit to edit record schedule.
5. Choose the day in a week to configure scheduled recording.
1) Configure All Day or Customize Record:
� If you want to configure the all-day recording, please check the All Day checkbox.
� If you want to record in different time sections, check the Customize checkbox. Set the Start Time
and End Time.
The time of each segment cannot be overlapped. Up to 8 segments can be configured.
2) Select a Record Type. The record type can be Continuous, Motion, Alarm, Motion & Alarm, and
Motion | Alarm.
3) Check the checkbox of Select All and click Copy to copy settings of this day to the whole week. You
can also check any of the checkboxes before the date and click Copy.
4) Click OK to save the settings and exit the Edit Schedule interface.
6. Click Advanced to configure advanced record parameters.
7. Click Save to validate the above settings.
Next page
Open/Close audio
/
Start/Stop two-way Audio
/
Adjust volume
14
NUVICO