Specifications - Nuvico HDoCS DT-P1620 Setup Manual

Setup Guide of HDoCS Digital Video Recorder
To connect PTZ to the DVR:
1. Disconnect pluggable block from the RS-485 terminal block.
2. Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
3. Connect A+ on PTZ to T+ on terminal block and B- on controller to T- on terminal block. Fasten stop
screws.
4. Connect pluggable block back into terminal block.
To connect a controller to the DVR:
1. Disconnect pluggable block from the KB terminal block.
2. Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
3. Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop
screws.
4. Connect pluggable block back into terminal block.
Make sure both the controller and DVR are grounded.

Specifications

Table 1 Specification for HD DVR
Video compression
Analog and HD-TVI
video input
Video/Audio Supported camera
input types
Audio compression
Audio input / Two-way
audio in
HDMI / VGA output
Encoding resolution
Video/Audio
output
Frame rate
Video bitrate
Audio output
Audio bitrate
H.264
16-ch
BNC interface (1.0Vp-
720P25, 720P30, 720P50, 720P60, 1080P25, 1080P30, CVBS
G.711u
4-ch Audio In/ 1ch Out, RCA (2.0 Vp-
1920 × 1080 / 60 Hz,1280 × 1024 / 60 Hz, 1280 × 720 / 60 Hz, 1024 × 768 / 60
Hz
Main stream: 1080P(non-real-time) / 720P / VGA / WD1 / 4CIF / CIF
Sub-stream: WD1(non-real-time) / 4CIF(non-real-time) / CIF / QCIF / QVGA
Main stream: 1/16 fps ~ Real time frame rate
Sub-stream: 1/16 fps ~ Real time frame rate
32 Kbps-6 Mbps
1-
64 Kbps
10
NUVICO