Component Names And Functions - Omron FJ-300 Series Instruction Manual

Component Names and Functions

●
LCD integrated type
FJ-3000/FJ-3005/FJ-H3000/FJ-H3005
Left-side view
67 Power/
ground terminal
1 POWER LED
2 RUN LED
3 ERROR LED
●
Box type
FJ-3050/FJ-3055/FJ-H3050/FJ-H3055
5 Camera connector
A Ethernet connector
8 Monitor connector (analog RGB)
67 Power/ground terminal
4 I/O connector (control lines, data lines)
1 Lit while power is ON.
2 Lit or turned off according to the layout under the display.
3 Lit when an error has occurred.
4 Connect the controller to external devices such as a sync sensor and PLC.
5 Connect cameras.
6 Connect a DC power supply. Wire the power supply unit independently of
other devices. After wiring, replace the terminal cover.
Power Supply and Wiring p.3
7 Connect the ground wire. Make sure that the controller is grounded with a
separate ground wire.
8 Connect a monitor.
9 Connect an external device such as a personal computer or PLC.
0 Connect a track ball, mouse and USB memory. A total of four USB ports are provided and any of them can be
used. However, when connecting two or more USB memories, do not connect them to adjacent ports. Doing so
may cause the USB memories to come into contact, resulting in malfunction or damage.
• The following items can be connected to USB ports.
• Never insert/remove USB devices during measurement. Doing so may affect measurement time.
A Connect the controller to a personal computer.
B A touch pen is stored. (Provided with the LCD integrated type only)
• The touch pen must be stored so that the pen tip faces to the right when viewed toward the controller.
• To remove the touch pen, push the left side (handle) of the pen to the rear. The pen's right side (pen tip) will pop out, so hold
and remove the pen.
Front view Right-side view
0 USB connector
B Touch pen (holder)
• Commercially available track ball and mouse
9 RS-232C/RS-422
connector
4 I/O connector
(control lines, data lines)
8 Monitor connector
(analog RGB)
A Ethernet connector
5 Camera connector
0 USB connector
1 POWER LED
2 RUN LED
3 ERROR LED
0 USB connector
9 RS-232C/RS-422 connector
Power Supply Wiring
24VDC
+
–
• USB memory
6