Table of Contents
Advertisement
●
Noise Resistance
•
Do not install the product in a cabinet containing
high-voltage equipment.
•
Do not install the product within 200 mm of power cables.
●
Component Installation and Handling
•
Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for preventing electrostatic discharges when touching
terminals or signal lines in connectors.
•
Handling a USB Memory
To remove a USB memory, make sure that data is not being read or written to it.
The LED on the USB memory flashes while data is being read or written, so make sure that it is lit steadily before removing the
memory.
•
Turning OFF the Power
Do not turn OFF the power while a message is being displayed indicating that processing is being performed. Data in memory will
be corrupted, and the product may not operate correctly the next time it is started.
•
Using the RESET Signal
Do not use the RESET input immediately after power is turned ON. When using the RESET input to synchronize startup timing, wait
at least 15 second after the Controller's power supply is turned ON before turning ON the RESET signal.
•
The LCD panel used for the LCD-integrated type (FJ-300_/FJ-300_-10/FJ-H300_/FJ-H300_-10) has been made using precision
technology, and sometimes a few pixcels are missing in the panel. This is due to the structure of the LCD panel, and is not a
malfunction.
●
Maintenance
Turn OFF the power and take safety precautions before conducting inspections. Electrical shock can result from attempting safety
inspections with the power turned ON.
•
Clean the lens with a lens-cleaning cloth or air brush.
•
Lightly wipe off dirt with a soft cloth.
•
Dirt on the CCD must be removed using an air brush.
•
Do not use thinners or benzene.
●
Communication with High-order Device
After confirming that this product is started up, communicate with the high-order device.
When this product has started up, an indefinite signal may be output from the high-order interface.
To avoid this problem, clear the receiving buffer of your device at initial operations.
Confirming Package Contents
•
Controller ............................................................ Qty:1
•
Instruction Manual (this manual) ........................ Qty:1
Member Registration Sheet ................................ Qty:1
•
•
Mounting bracket (for panel) ............................... Qty:6
•
Touch pen ........................................................... Qty:1
U.S. California Notice:
This product contains a lithium battery for which the following notice applies :Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
Mercury content
LCD-integrated controllers (FJ-300_/FJ-H300_/FJ-300_-10/FJ-H300_-10) contain mercury in the fluorescent tube.
Observe local ordinances and regulations regarding disposal.
* Supplied with the LCD integrated type only.
* Supplied with the LCD integrated type only.
(Provided inside the controller)
4
Advertisement
Table of Contents
