Measurements; General Information About High Voltage Testing; The Purpose Of Insulation Tests; Dc Vs. Ac Testing Voltage - METREL TeraOhmXA 10 kV Instruction Manual

MI 3210 TeraOhm XA 10kV

5 Measurements

5.1 General information about high voltage testing

5.1.1 The purpose of insulation tests

Insulating materials are important parts of almost every electrical product. The material's
properties depend not only on its compound characteristics but also on temperature,
pollution, moisture, ageing, electrical and mechanical stress, etc. Safety and operational
reliability require the regular maintenance and testing of the insulation material to ensure
it is kept in good operational condition. High voltage tests are used to test insulating
materials.

5.1.2 DC vs. AC testing voltage

Testing with a DC voltage is widely accepted as being useful as testing with AC and / or
pulsed voltages. DC voltages can be used for breakdown tests especially where high
capacitive leakage currents interfere with measurements using AC or pulsed voltages.
DC is mostly used for insulation resistance measurement tests. In this type of test, the
voltage is defined by the appropriate product application group. This voltage is lower
than the voltage used in the withstanding voltage test so the tests can be applied more
frequently without stressing the test material.

5.1.3 Typical insulation tests

In general, insulation resistance tests consist of the following possible procedures:
Simple insulation resistance measurement also called a spot test;

Measurement of the relationship between voltage and insulation resistance;

Measurement of the relationship between time and insulation resistance

Test of residual charge after the dielectric discharge.

The results of this test can indicate whether the replacement of the insulation system is
required.
Typical examples of where testing insulation resistance and its diagnosis are
recommended are transformer and motor insulation systems, cables and other electrical
equipment.
30
Measurements