Installing The Power Connector Port; Removing The System Board - Dell PP50F Owner's Manual

Installing the power connector port

1 Insert the power connector port into the slot on the computer.
2 Route the power connector port cable through the routing channels.
3 Connect the power connector port cable to the connector on the system board.
4 Tighten the screw to secure the power connector port to the computer.
5 Install the:
a display cable
b palmrest
c keyboard
d hard drive assembly
e base cover
f battery
6 Follow the procedure in

Removing the system board

1 Follow the procedure in
2 Remove the:
a battery
b base cover
c hard drive assembly
d WLAN card
e memory
f keyboard
g palmrest
h display cable
i system fan
3 To remove the system board:
a Disconnect the power port cable [1], VGA board cable [2], I/O board cable [3], and speaker cable [4] from the connectors on the
system board.
20 Removing and installing components
After Working Inside Your computer.
Before Working Inside Your Computer.