Chapter 2: Hardware Setup; Tools And Parts For Component Installation; Install Drives - Synology NAS RS1221RP+ Hardware Installation Manual

Hardware Setup

Tools and Parts for Component Installation

Please prepare below tools and parts before setting up your Synology NAS:
• A screwdriver
• At least one 3.5" or 2.5" SATA drive (please visit
models)
Warning: If you install a drive that contains data, the system will format the drive and erase all existing data.
Please back up any important data before installation.
• Rail mounting kit (please see the Optional Accessories section to find out the suitable rail kit for cabinet
installation)
Warning:
We suggest mounting your Synology NAS on a cabinet before installing any drives since the heavy
weight will increase the installation difficulty.

Install Drives

Please follow the steps below for drive installation:
1 To remove the drive tray, pull out the drive tray handle in the direction as shown in the image below.
2 Install drives:
• For 3.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive in place.
• For 2.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive in place.
12
www.synology.com/compatibility for compatible drive
2
Chapter