Chapter 2: Hardware Setup; Tools And Parts For Component Installation; Install Drives - Synology NAS SA3600 Hardware Installation Manual

Hardware Setup

Tools and Parts for Component Installation

Please prepare below tools and parts before setting up your Synology NAS:
• A screwdriver
• At least one 3.5" or 2.5" SAS/SATA drive (please visit
models)
Warning: If you install a drive that contains data, the system will format the drive and erase all existing data. Please
back up any important data before installation.
• Rail mounting kit (please see the Optional Accessories section to find out the suitable rail kit for cabinet
installation)
Warning:
We suggest mounting your Synology NAS on a cabinet before installing any drives since the heavy weight
will increase the installation difficulty.

Install Drives

Please follow below steps for drive installation:
1 Open the drive tray.
a Find the small button located on the left side of the drive tray handle. Press the button down, and the drive
tray handle will pop out.
b Pull the drive tray handle out as illustrated above.
2 Install drives:
• For 3.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive.
• For 2.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive.
9
www.synology.com/compatibility
2
Chapter
for compatible drive