Table of Contents
Advertisement
Install a PCle Add-in Card
RS1221RP+ provides one PCIe slot for optional add-in card expansion, allowing network interface card to be
installed.
To install network interface card
1 Follow step 1 and 2 of the "To install the memory module" section to shut down your Synology NAS,
disconnect the cables and remove the top cover.
2 Install the network interface card:
a Remove the screw that secures the expansion slot's cover. Remove the cover from the expansion slot.
b Align the card's connector with the expansion slot and insert the card into the slot.
c Place back the latch and fasten the screw that you removed in step 2-a to secure the newly inserted card in
place.
Note:
Confirm that the connector is fully inserted. Otherwise, the network interface card might not be able to
function properly.
3 Replace the top cover by following step 5 of the "To install the memory module" section.
4 Reconnect the cables that removed, then press the power button to turn on your Synology NAS.
17 Chapter 2: Hardware Setup
Advertisement
Table of Contents
