Table of Contents
Advertisement
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.4 Deactivating Wi-Fi on the
appliance
Press and hold
1.
three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press
repeatedly until the dis-
3.
play shows oFF.
a Wi-Fi is deactivated.
Note: The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.5 Resetting the appliance
network settings
Press and hold
1.
3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press
.
3.
a The display shows Yes.
Press
.
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Note
Remote start is deactivated for safety
reasons in the following
circumstances:
¡ The appliance door is opened.
is pressed.
¡
is pressed.
¡
¡ The appliance is switched off.
¡ Following a power cut.
for at least
for at least
Activating remote start
Requirements
¡ The appliance is connected to your
home WiFi network.
¡ The appliance is connected to the
Home Connect app.
¡ A programme is selected.
¡ The appliance door is closed.
¡ The detergent drawer has been
pushed in.
Press
.
▶
lights up and the appliance is
a
enabled for remote start via the
Home Connect app.
Deactivating remote start
Press
.
▶
goes out.
a
16.7 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.
Home Connect en
37
Advertisement
Table of Contents
